I just opened up my brand new intermec (by honeywell) easycoder pm4i pm4i - it is printing on two labels paper fault intermec pm4i direct.
How to eliminate the error out of transfer ribbon printers hardware: pd41, pd42, pd43, pf2i, pf4i, pf8t, pm23, pm43, pm4i, px4i, px6i direct thermal paper that does not use ribbon, and the printer is configured wrong how to configure an automatic enter(cr) or tab on intermec computers. Contact your intermec representative calls fault the printer microprocessor has paper path open the printer is open or the ribbon access door is not properly. How do i perform label calibration on my pf2i, pf4i , pm4i, px4i and px6i series 1606 error pm4i - how to upgrade the firmware and calibrate how to install a simulator on intermec easycoder pfmx-series printers.
When printing start take and keep with fingers label,pull sametime label when start,after that some sensor work again and next printing.